View source for Template:Mounting Recommendations


== Mounting Recommendations ==
[[File:Orientatoin 1.png|frame|left|10px]]
=== Connecting Wires ===

*Ensure the device is not powered or plugged in when connecting wires.
*Fasten all wires to stable, non-moving parts to avoid damage from vibration or mechanical movement.
*Keep wires away from heat sources and components with moving parts.
*No wire should remain exposed. If factory insulation was removed during installation, apply proper insulation afterward.
*For wires routed in areas exposed to heat, moisture, dirt, or external conditions, apply additional protective insulation and ensure they are firmly secured.
*Do not connect the wires directly to vehicle control units or onboard computers.

=== Connecting Power Source ===

*After the vehicle’s computer enters sleep mode, power may still remain on certain power lines. This delay varies by vehicle and may take 5 to 30 minutes.
*After connecting the module, measure the voltage again to ensure it remains stable.
*It is recommended to connect the device to the main power supply line inside the fuse box. Device is protected using an internal Self resettable fuse 3A, 100V

=== Connecting Ignition Wire ===

*Verify that the selected line is a true ignition wire, meaning power remains present after the engine starts.
*Ensure the wire is not an ACC (accessory) line, which only has power in the key’s first position.
*Check that power remains available when turning off any individual vehicle devices.
*The ignition wire should be connected to the ignition relay output, or alternatively to any relay that provides output only when the ignition is ON.

=== Connecting Ground Wire ===

*Connect the ground wire to the vehicle chassis or metal parts firmly attached to the frame.
*If the wire is secured using a bolt, attach a ring/loop terminal to the wire end.
*For the best electrical contact, remove paint from the mounting spot before securing the loop terminal.