Jump to content

Automotive Relay

From Transight Wiki
Revision as of 10:16, 21 October 2025 by Editor (talk | contribs) (Created page with "200px|right ==Introduction to the product== Automotive relays are the common type of electromechanical relay that are used in all types of vehicles, like car, trucks, vans and trailers. They enable a small current flow circuit to control and operate a higher current circuit in vehicular applications and can be used with various solutions and provide useful use cases. ==Configuration guide== This guide provides the configuration steps for Immobilizer re...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Introduction to the product

Automotive relays are the common type of electromechanical relay that are used in all types of vehicles, like car, trucks, vans and trailers. They enable a small current flow circuit to control and operate a higher current circuit in vehicular applications and can be used with various solutions and provide useful use cases.

Configuration guide

This guide provides the configuration steps for Immobilizer relay with Transight Telematics devices using commands.

• Command Format

SET CUIOCFG:<IO Number>-<IO Mode>-<IO Function*>

• Example

SET CUIOCFG:IO1-DO-IMB*

• Expected Response

IMEI: 862942074896945
 Command: SET CUIOCFG:IO1-DO-IMB*

 Response:  
Error : 0

• Verification Command

GET CUIOCFG

• Expected Verification Response

IMEI: 862942074896945
 Command: GET CUIOCFG
 
 Response: CUIOCFG:
IO1-AN-GEN*IO2-DI-GEN*IO3-DO-IMB 
Error : 0

• Immobilizer ON/OFF Commands

SET CUIMOB:ON

SET CUIMOB:OFF

• Immobilizer check Command

GET CUIMOB

• Expected Response Format

IMEI: 862942074896945
 Command: GET CUIMOB
 
 Response: IMOB:OFF 
Error : 0

Immobilizer Scenario

The immobilizer relay operates through the Digital Output (DO) function of the Transight Telematics device. The general-purpose I/O pins are multiplexed and configurable. The pin configuration for the immobilizer is provided below.
The immobilizer will only activate when the following conditions are met at the time of sending the command:
1. Vehicle ignition is OFF, or
2. Vehicle ignition is ON and GPS fix is active, or
3. Vehicle ignition is ON and vehicle speed ≤ 10 km/h.

Wiring Information

Relay PIN Relay cable color Connection
30 Blue Common connection to NO & NC terminals
85 Black Coil
86 White Coil
87 Yellow Normally Open (NO)
87a Red Normally Closed (NC)

Product Specification

Parameter Value
Contact Rating 30A/40A 14VDC
Coil Voltage 12VDC
Coil Power 1.8W
Release Voltage ≥10%
Pickup Voltage ≤70%
Insulation Resistance 100Ω
Contact Resistance 100Ω
Between open contact 500VAC
Between coil & contact 750VAC
Temperature Range -55~+85℃
Dimension 25.0x27.4x28.4
Weight 40g
Supported by

DISCOVERY-116A, DISCOVERY-126A, DISCOVERY-206A, DISCOVERY-226A, DISCOVERY-296A,