STRELA FUEL SENSOR
Introduction to the Product
Strela Fuel Level Sensor (FLS) with RS232 output interface is designed for measuring fuel and lubricant (POL) levels. It is suitable for use in vehicles and fuel depots as part of fuel monitoring and control systems.
FLS can measure fuels such as gasoline, diesel, and oil. It determines fuel levels, converts them into volume (if recalibration tables are unavailable, output is proportional to level), and transmits data over RS-232 using the Modbus or Omnicomm protocol. The sensor is compatible with display units or programmable controllers that match its electrical signal specifications.
Product Specification
| Parameter | Value |
|---|---|
| Power supply voltage | 10 – 30 V |
| Consumption current | 20 mA |
| Communications protocol | Modbus, Omnicomm |
| Default data transmission rate | 19200 bit/sec |
| Supported data rates | 9600, 14440, 19200, 38400, 57600, 115200 bit/sec |
| Low limit fuel level from bottom | From 20 mm |
| High limit measuring range | 200 – 4000 mm |
| Measurement error | ±1% of sensor length |
| Dimensions | L × 70 × 70 mm |
| Operating temperature range | -40°C to +70°C |
| Relative humidity at ≤ +40°C | ≤ 95% |
| Operating life | Unlimited |
Wiring Information
| Wire Color | Function |
|---|---|
| Red | Power |
| Brown | Ground |
| Green | Rx |
| Yellow | Tx |
Communication Notes
- Data communication is available through both RS232 and RS485 interfaces.
- The sensor supports Modbus and Omnicomm protocols for integration into various telemetry and automation systems.
- Output value is proportional to fuel level unless specific recalibration tables are applied.